Not sure if we come to you? If you’re within about half an hour of Moncton, the answer is probably yes. Call (506) 405-9905 and ask.
Moncton
New Brunswick’s largest city has every kind of house siding can go on: older two- and three-storeys in the neighbourhoods around downtown, mid-century bungalows, and newer subdivisions on the north side. A lot of the older houses carry aluminum or an early generation of vinyl that’s now brittle and faded.
Typical jobs here are full vinyl replacement on houses whose first siding has faded and cracked, and repairs after windstorms. On older houses, taking off a layer of aluminum often turns up the original wood clapboard and sheathing that needs some work first.

Dieppe
Next door to Moncton on the east side, Dieppe is a largely francophone city with many newer subdivisions alongside older homes near its centre. Newer houses often want a sharper look: dark vinyl or engineered wood on the front, board and batten on a gable, or a steel accent.
Much of Dieppe is low and open, near the Petitcodiac and its marshes, so wind reaches houses with little in the way. Fastening and starter strip matter as much here as anywhere.

Riverview
Across the Petitcodiac from Moncton, Riverview is a mostly residential town of family homes, many of them two-storeys and split-levels with large plain walls. That’s where the siding choice shows most: a deep shadow line from engineered wood lap, or a two-tone scheme with shakes in the gables, changes the whole house.
Where a house is still on its first siding, replacing soffit, fascia and eavestroughs at the same time is common and saves on staging.
Shediac and Shediac Bridge
On Shediac Bay, just off the Northumberland Strait, salt air and wind are part of every siding decision. Cottages and year-round houses near the beaches see spray and sand, and anything metal on the wall wears faster.
Here we lean toward vinyl, fibre cement and cedar shingles with stainless fasteners, and away from aluminum. Cottage work can be booked for the shoulder season, before or after the summer crowds.

Cap-Pelé
Further east along the Strait, the Acadian village of Cap-Pelé faces the open water. Houses and cottages here take the full force of storms off the Strait, as post-tropical storm Fiona showed in 2022.
Cedar shingles suit the shore’s look and handle salt well when they’re fastened with stainless steel. For lower upkeep, heavier vinyl or fibre cement are the other strong choices.
Memramcook
Southeast of Moncton, the Memramcook valley has older farmhouses, Acadian homes and newer houses on rural lots. Older farmhouses often have several layers of siding to come off, and sometimes original wood that deserves a careful look before it’s covered again.
Barns, garages and outbuildings out here are good candidates for steel siding, which is cheap to keep up on a long plain wall.
Salisbury
West of Moncton along the Trans-Canada, Salisbury is a village with a mix of older homes and newer houses on larger lots. It’s inland, away from salt air, so steel is a fair choice here for garages, workshops and modern fronts, alongside vinyl for the house itself.
Lakeville, Irishtown, Lutes Mountain and Berry Mills
The rural-residential communities just north and west of Moncton have larger lots, detached garages and plenty of houses built in the last few decades. Typical jobs are a full re-side when the first vinyl has faded, matching siding on a new garage or addition, and steel on outbuildings.
Exposed lots on the higher ground get more wind than houses in town, so starter strip, fastening and a secure top course are worth asking about.
Further out
For places further from Moncton, such as Sackville, Hillsborough or Bouctouche, call and ask. Larger jobs may be possible depending on the schedule.