Metal and steel siding in Greater Moncton

Steel panels for modern fronts, garages and outbuildings, steel lap boards with a wood-grain finish, and the facts on aluminum.

Steel siding costs about $25.20 to $40.00 per square foot installed in Canada and aluminum about $7.20 to $10.00 (HomeStars). Aluminum may corrode near saltwater, so it’s a weaker choice on the Shediac coast.

This page covers steel and aluminum siding and metal exterior cladding on houses and outbuildings. For fixing old aluminum siding, see siding repair. For metal fascia and soffit, see soffit, fascia and eavestroughs.

Kinds of metal siding

Steel panels

Long, ribbed or flat steel panels, usually run vertically. They’re the look behind many modern farmhouse and contemporary fronts: a dark vertical wall, often mixed with wood-look accents. On garages, workshops and barns, steel panels are the standard cladding.

Steel lap and board siding

Steel formed into lap boards or board and batten, with a painted or printed wood-grain finish. It looks like painted wood from the street and doesn’t need painting.

Aluminum siding

The siding on many older houses around Moncton. HomeStars gives it about 40 years and $7.20 to $10.00 per square foot installed. It doesn’t rust, but it dents easily, the paint chalks over time, and HomeStars notes it may corrode near saltwater.

Modern house with charcoal vertical steel siding and natural wood accents
Illustrative image, not a photo of a completed job.

Why choose steel

  • Durability. HomeStars calls steel highly durable with minimal upkeep.
  • Fire. It doesn’t burn or melt.
  • Pests. Nothing for woodpeckers or insects to work on.
  • Looks. Clean, sharp lines and deep colours that suit modern houses.
  • Long runs. Panels can run the full height of a wall with no horizontal joints.

The trade-offs

Steel is the most expensive common siding in HomeStars' guide, at $25.20 to $40.00 per square foot installed. It can dent from a hard hit, and a deep scratch through the coating can rust if it’s left alone. It’s also louder in heavy rain and hail than vinyl or fibre cement, though insulation behind the wall softens that.

Metal moves with temperature like vinyl does, so panels are fastened with that in mind, with clips or slotted holes where the system calls for them.

Planning a steel front, garage or outbuilding?

Call (506) 405-9905

Metal siding near the shore

This is where Moncton’s geography matters. Along the Northumberland Strait in Shediac, Shediac Bridge and Cap-Pelé, salt carried on the wind lands on every wall. Coated steel and aluminum both suffer once the finish is scratched, and fasteners and cut edges are where corrosion starts.

For a house right on the water, we’d usually point you toward vinyl, fibre cement or cedar shingles instead. Inland in Moncton, Dieppe, Riverview and Salisbury, steel is a solid choice, especially on garages and accents.

Mixing metal with other siding

Some of the best-looking houses use metal for one part of the wall: a charcoal steel entry bump-out against light vinyl lap, or vertical steel on the lower floor with engineered wood above. Where two materials meet, the joint needs proper trim and flashing so water can’t get behind either one.

Installation basics

  • Old siding off and the wall checked, then house wrap and strapping.
  • Trim, corners and flashing installed first, the way the panel system specifies.
  • Panels cut with tools that don’t burn the coating, and fasteners matched to the panel.
  • Cut edges and any scratches touched up before the crew leaves.

Cost

From HomeStars' Canadian guide: steel $25.20 to $40.00 and aluminum $7.20 to $10.00 per square foot installed. RenoQuotes' 2026 guide lists aluminum at $17 to $23, which shows how much guides disagree. Outbuildings with simple walls cost less per square foot than a house with many corners and windows. The cost guide compares every material.

Thinking about new siding? Start with a free look.

Call to describe the house, or send the form and we call you back. Quotes are free and written.

(506) 405-9905
  • A free visit to measure and look at what’s under the old siding
  • A written quote that lists removal, wrap, trim and disposal
  • Moncton, Dieppe, Riverview, Shediac and the villages around them

Or send the details

Tell us about the house. We call back to talk it through and book a free visit.

We only use your details to reply about your house. See the privacy note.

Call now Free quote